EN 62282-3-200:2016

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, operating process and symbols
4 Reference conditions
5 Item of performance test
6 Test preparation
7 Measurement instruments and measurement
   methods
8 Test plan
9 Test methods and computation of test results
10 Test reports
Annex A (normative) - Uncertainty analysis
Annex B (normative) - Calculation of fuel heating
        value
Annex C (normative) - Reference gas
Annex D (informative) - Maximum acceptable instantaneous
        electric power output transient
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

IEC 62282-3-200:2015 covers operational and environmental aspects of the stationary fuel cell power systems performance. The test methods apply as follows:- power output under specified operating and transient conditions;- electrical and heat recovery efficiency under specified operating conditions;- environmental characteristics;- for example, exhaust gas emissions, noise, etc. under specified operating and transient conditions. This new edition includes the following significant technical changes with respect to the previous edition: a stabilization zone of +- 10 % for thermal output of 100 % response time is provided instead of the tests for thermal output of 90 % response time, while the tests for electric output of 90 % response time remain as an option; the calculations for the ramp rate in kW/s are deleted and only the calculations for the response time (s) remain.