EN ISO 10893-10:2011

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Test method
6 Reference tube
7 Equipment calibration and checking
8 Acceptance
9 Test report
Annex A (normative) - Testing on longitudinal
        imperfections of tubes with a ratio of the specified
        outside diameter to the average of the specified
        thickness range less than 5
Annex B (normative) - Manual/semi-automated testing of
        untested ends and suspect areas

ISO 10893-10:2011 specifies requirements for automated full peripheral ultrasonic shear wave (generated by conventional or phased array technique) testing of seamless and welded [except submerged arc-welded (SAW)] steel tubes, for the detection of longitudinal and/or transverse imperfections.In the case of testing on longitudinal imperfections, Lamb wave testing can be applied at the discretion of the manufacturer.For seamless tubes, by agreement between the purchaser and manufacturer, testing principles of ISO 10893-10:2011 can be applied to detect imperfections having other orientations.ISO 10893-10:2011 is applicable to the inspection of tubes with an outside diameter greater than or equal to 10 mm, normally with an outside diameter-to-thickness ratio greater than or equal to 5.It can also be applicable to the testing of circular hollow sections.