EN ISO 2553:2013

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Welding symbol
5 Dimensioning of welds
6 Dimensioning of joint preparations
7 Alternative butt weld symbol with required
  weld quality
Annex A (informative) - Examples of the use
        of welding symbols
Annex B (informative) - Tolerances and transition
        points for weld types
Annex C (informative) - Alternative methods for
        designating intermittent butt and fillet welds
Bibliography

ISO 2553:2013 defines the rules to be applied for symbolic representation of welded joints on technical drawings. This may include information about the geometry, manufacture, quality and testing of the welds. The principles of this standard may also be applied to soldered and brazed joints.It is recognized that there are two different approaches in the global market to designate the arrow side and other side on drawings. In ISO 2553:2013: sections, tables and figures which carry the suffix letter "A" are applicable only to the symbolic representation system based on a dual reference line; sections, tables and figures which carry the suffix letter "B" are applicable only to the symbolic representation system based on a single reference line; sections, tables and figures which do not have the suffix letter "A" or "B" are applicable to both systems.The symbols shown may be combined with other symbols used on technical drawings, for example to show surface finish requirements.An alternative designation method is presented which may be used to represent welded joints on drawings by specifying essential design information such as weld dimensions, quality level, etc. The joint preparation and welding process(es) are then determined by the production unit in order to meet the specified requirements.