EN ISO 7786:2001

Foreword
Introduction
1 Scope
2 Normative references
3 Symbols
4 Requirements
   4.1 Materials
   4.2 Shapes
   4.3 Dimensions
   4.4 Specifications for dental laboratory abrasive
       instruments
   4.5 Run-out
5 Test procedures
   5.1 Shapes
   5.2 Dimensions
   5.3 Run-out
6 Sampling and acceptance level (AQL)
7 Manufacturer's instructions
8 Marking on abrasive instruments
9 Labelling
10 Packaging
Bibliography

Describes dimensional and other relevant requirements for the six most commonly available shapes of ceramic bonded abrasive instruments used for grinding in the dental laboratory, including a quality control and specifications for labelling of these instruments.