I.S. EN 14364:2013
Superseded
View Superseded by
PLASTICS PIPING SYSTEMS FOR DRAINAGE AND SEWERAGE WITH OR WITHOUT PRESSURE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON UNSATURATED POLYESTER RESIN (UP) - SPECIFICATIONS FOR PIPES, FITTINGS AND JOINTS
Hardcopy , PDF
English
01-01-2013
12-31-2021
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 General requirements
5 Pipes
6 Fittings
7 Joint performance
Annex A (normative) - Test method for the resistance
to bending and pressure of end-thrust loaded
joints in pipe systems
Bibliography
Describes the required properties of the piping system and its components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) intended to be used for drainage or sewerage, including culverts, with or without pressure.
| DevelopmentNote |
Supersedes I.S. EN 1115-1, I.S. EN 1115-3, I.S. EN 1115-5, I.S. EN 1636-3 and I.S. EN 1636-5. (06/2006)
|
| DocumentType |
Standard
|
| Pages |
74
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| DIN EN 14364:2013-05 | Identical |
| NS EN 14364 : 2013 | Identical |
| BS EN 14364:2013 | Identical |
| NEN EN 14364 : 2013 | Identical |
| NBN EN 14364 : 2013 | Identical |
| NF EN 14364 : 2013 | Identical |
| EN 14364:2013 | Identical |
| UNE-EN 14364:2015 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.