I.S. EN 14825:2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
AIR CONDITIONERS, LIQUID CHILLING PACKAGES AND HEAT PUMPS, WITH ELECTRICALLY DRIVEN COMPRESSORS, FOR SPACE HEATING AND COOLING - TESTING AND RATING AT PART LOAD CONDITIONS AND CALCULATION OF SEASONAL PERFORMANCE
Hardcopy , PDF
03-04-2023
English
04-10-2016
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
National Foreword
European foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols, abbreviated
terms and units
4 Part load conditions in cooling mode
5 Part load conditions in heating mode
6 Calculation methods for SEER and SEER[on]
7 Calculation methods for seasonal space
heating efficiency eta[s], SCOP, SCOP[on] and
SCOP[net]
8 Test methods for testing capacities, EER[bin]
and COP[bin] values during active mode at
part load conditions
9 Test methods for electric power input
during thermostat-off mode, standby mode
and crankcase heater mode and off mode
10 Test report
11 Technical data sheet
Annex A (normative) - Applicable climate bin hours
and hours for active mode, thermostatoff,
standby, off mode and crankcase heater mode
for air conditioners below and equal to 12 kW
Annex B (normative) - Applicable climate bin hours
and hours for active, thermostat-off, standby, off
and crankcase heater modes for space heaters, air
to water and water/brine to water units, below
or equal to 400kW
Annex C (normative) - Template for technical data sheet
Annex D (informative) - Adaption of water temperature
for fixed capacity units
Annex E (informative) - Calculation example for
SEER[on] and SEER - Application to a
reversible air-to-air unit with variable capacity
Annex F (informative) - Calculation example for
SCOP[on] and SCOP[net] - Application to a fixed
capacity air-to-water heat pump used
for floor heating
Annex G (informative) - Calculation example for
SCOP[on] and SCOP[net] Application to a
fixed capacity brine-to-water heat pump
used for medium temperature application
Annex H (informative) - Compensation methods
for air-to-water and water/brine-to-water units
Annex ZA (informative) - Relationship between
this European Standard and the requirements
of Commission Regulation (EU) No 206/2012
Annex ZB (informative) - Relationship between
this European Standard and the requirements
of Commission Regulation (EU) No 813/2013
and Commission Delegated Regulation
(EU) No 811/2013
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.