I.S. EN 15061:2007
Superseded
View Superseded by
SAFETY OF MACHINERY - SAFETY REQUIREMENTS FOR STRIP PROCESSING LINE MACHINERY AND EQUIPMENT
Hardcopy , PDF
English
11-28-2007
04-09-2022
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
5.1 General design requirements
5.2 List of significant hazards, hazardous situations,
safety requirements and/or measures for terminal
equipment
5.3 List of significant hazards, hazardous situations,
safety requirements and/or measures for processing
equipment
5.4 Special safety requirements or measures
5.5 Noise reduction as a safety requirement
6 Verification of the safety requirements and/or measures
7 Information for use
7.1 General
7.2 Safety signs and warning devices
7.3 Minimum marking
7.4 Instruction handbook
7.5 Maintenance manual
Annex A (normative) Safety requirements and/or measures for
electrical equipment
A.1 Foreword
A.2 Special requirements for controls
A.3 Special requirements for shut-down equipment
Annex B (normative) Noise test code
B.1 Introduction
B.2 Determination of A-weighted sound power level
B.3 Determination of A-weighted emission sound pressure
levels at work stations
B.4 Measurement uncertainty
B.5 Operating conditions
B.6 Information to be recorded and reported
B.7 Declaration and verification of noise emission values
Annex C (informative) Example for manufacturer's safety
instructions for maintenance at strip processing lines
C.1 Hazards caused by a lack of instructions
C.2 Hazards caused by visual or audible checks
at machinery in motion
C.3 Hazards caused by unintentional movements during
maintenance
C.4 Hazards at work during standstill with safeguards
disabled
C.5 Hazards arising from work with hazardous substances
C.6 Hazards arising from plant re-start
Annex D (informative) Exemplary solutions
Annex ZA (informative) Relationship between this European
Standard and the Essential Requirements of EU Directive
98/37/EC
Annex ZB (informative) Relationship between this European
Standard and the Essential Requirements of EU
Directive 2006/42/EC
Bibliography
Describes the health and safety requirements of strip processing lines.
| DevelopmentNote |
2007 Edition Re-Issued in February 2009 & incorporates AMD 1 2009. (02/2009)
|
| DocumentType |
Standard
|
| Pages |
92
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NF EN 15061 : 2007 + A1 2009 | Identical |
| NS EN 15061 : 2007 + A1 2008 | Identical |
| NEN EN 15061 : 2007 + A1 2009 | Identical |
| BS EN 15061 : 2007 | Identical |
| DIN EN 15061:2009-05 | Identical |
| EN 15061:2007+A1:2008 | Identical |
| EN 15061:2007 | Equivalent |
| UNE-EN 15061:2007 | Equivalent |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.