I.S. EN 15434:2006

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Sealant
5 Requirements
6 Sealing and bonding
7 Compatibility with adjacent material
8 Evaluation of conformity
9 Marking and/or labelling
Annex A (normative) - Evaluation of mechanical tests results
Annex B (normative) - Shear at 23 degrees C: Test method
Annex C (normative) - Factory production control
Annex D (normative) - Outer seal of insulating glass category
        differentiation
Annex E (normative) - Formation of bubbles
Annex F (informative) - Sealing, structural bonding and
        UV resistance: schematic illustrations
Annex G (normative) - Initial testing of bonding of sealant
        to non-glass substrates
Annex V (informative) - Provisions for voluntary involvement
        of third party(ies)
Bibliography

Specifies the requirements for and testing of sealants for use in one or more of the following applications: a) Manufacturing of insulating glass units where ultra-violet resistance and/or mechanical resistance (structural use) of the insulating glass edge seal is required; b) Manufacturing of factory made structural sealant glazing elements when referred to by the relevant European Standards and/or European Technical Approval Guidelines; c) Assembling of glass products into or onto supports, where also ultra-violet resistance and/or mechanical resistance (structural use) of the seal is required, under controlled environmental conditions as described in Clause 5 of EN 13022-2: 2006.