I.S. EN 196000:1994

Cooperating organizations
National foreword
Foreword
Preface
Section one - Scope
1.1 Scope
1.2 Switch classes included
1.3 Switch classes excluded
Section two - General
2.1 Normative references
2.2 Units, symbols and terminology
2.3 Standard and preferred values
2.4 Marking
2.5 Safety requirements
Section three - Quality assessment procedure
3.1 Primary stage of manufacture
3.2 Structural similarity
3.3 Qualification approval procedure
3.4 Quality conformance inspection
3.5 Certified test records
3.6 Delayed delivery
3.7 Re-submission of rejected lots
3.8 Alternative test methods
3.9 Release for delivery before the completion of
        group B tests
3.10 Capability approval
3.11 Rework
Section four - Test and measurement procedures
4.1 Standard conditions for testing
4.2 Optional reduction of testing
4.3 Individual test methods
4.3.1 General examination
4.3.2 Electrical continuity and contact resistance
4.3.3 Insulation
4.3.4 Voltage stress
4.3.5 Current carrying capacity
4.3.6 Dynamic stress
4.3.7 Impact stress
4.3.8 Mechanical strength
4.3.9 Endurance
4.3.10 Overload
4.3.11 Climatic
4.3.12 Soldering
4.3.13 Mechanical operating characteristics
4.3.14 Sealing
4.3.15 Chemical resistance
4.3.16 Fire hazard
4.3.17 Capacitance
4.3.18 Illumination
4.3.19 Temperature response
Annex
A Test schedules for quality conformance
        inspection and qualification approval
National annex NA (informative) Committees responsible
National annex NB (informative) Cross-references

Specifies quality assessment and test and measurement procedures for electromechanical switches.