I.S. EN 298:2012

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Units of measurement and test condition
6 Constructional requirements
7 Performance
8 EMC/Electrical requirements
9 Marking, installation and operating instructions
Annex A (informative) - Gas connections in common use in the
        various countries
Annex B (informative) - Leak-tightness test - Volumetric method
Annex C (informative) - Leak-tightness - Pressure loss method
Annex D (normative) - Conversion of pressure loss into leakage rate
Annex E (normative) - Electrical/electronic component fault modes
Annex F (normative) - Additional requirements for safety
        accessories and pressure accessories as defined
        in EU 97/23/EC
Annex G (normative) - Materials for pressurized parts
Annex H (informative) - Additional materials for pressurized parts
Annex I (normative) - Requirements for controls used in DC
        supplied fuel burners and fuel burning appliances
Annex AA (informative) - Functional characteristics of burner
         control systems, to be given by the appliance standard
Annex BB (informative) - Fault modes of flame sensors
Annex CC (informative) - Functional diagrams of oil burner
         control systems
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU Directive
         2009/142/EC relating to appliances burning gaseous fuels
Bibliography

Describes the safety, construction and performance requirements for automatic burner control systems, programming units and flame detector devices, intended for use with gas and oil burners and gas and oil burning appliances, with or without fans and similar use.