I.S. EN 420:2003
Withdrawn
PROTECTIVE GLOVES - GENERAL REQUIREMENTS AND TEST METHODS
Hardcopy , PDF
English
01-01-2003
12-17-2009
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Comfort and efficiency
6 Test procedures
7 Marking and information
Annex A (informative) - Definition of "For minimal risks only"
Annex B (normative) - Pictograms
Annex C (informative) - Test results - Uncertainty of measurement
Annex ZA (informative) - Clauses of this European Standard
addressing essential requirements
or other provisions of EU Directives
Bibliography
Describes the general requirements and relevant test procedures for glove design and construction, resistance of glove materials to water penetration, innocuousness, comfort and efficiency, marking and information supplied by the manufacturer applicable to all protective gloves.
| DevelopmentNote |
2003 Edition Re-Issued in December 2009 & incorporates AMD 1 2009. (12/2009)
|
| DocumentType |
Standard
|
| Pages |
28
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Withdrawn
|
| Supersedes |
| Standards | Relationship |
| NF EN 420 : 2004 + A1 2010 | Identical |
| BS EN 420 : 2003 | Identical |
| NEN EN 420 : 2003 + A1 2009 | Identical |
| NS EN 420 : 2003 + A1 2009 | Identical |
| DIN EN 420:2010-03 | Identical |
| EN 420:2003+A1:2009 | Identical |
| NBN EN 420 : 1994 + A1 2010 | Identical |
| EN 420:2003 | Equivalent |
| UNE-EN 420:2004 | Identical |
| DIN EN 420:2003-12 | Equivalent |
This standard has been withdrawn and is no longer current. No replacement edition is available.