I.S. EN 60297-3-103:2004
Current
The latest, up-to-date edition.
MECHANICAL STRUCTURES FOR ELECTRONIC EQUIPMENT - DIMENSIONS OF MECHANICAL STRUCTURES OF THE 482,6 MM (19 IN) SERIES - PART 3-103: KEYING AND ALIGNMENT PIN
Hardcopy , PDF
English
01-01-2004
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Terms and definitions
4 Arrangement overview: Keying of plug-in units in a subrack
4.1 General
4.2 Subrack interface dimensions for keying
4.3 Plug-in unit keying interface dimensions
4.4 Key dimensions
4.5 Programming of keys
4.6 Keying chamber inspection dimensions
5 Arrangement overview: alignment and/or electrical contact
of a plug-in unit to a subrack
5.1 General
5.2 Alignment and/or electrical contact receptacle in the
subrack guide rail for printed board type plug-in units
(width dimension >= 4 x 5,08 mm)
5.3 Alignment and/or electrical contact interface
inspection dimensions
6 Arrangement overview: Subrack guide rail and printed board,
2,54 mm offset of the printed board reference plane
6.1 General
6.2 Dimensions of the subrack guide rail with 2,54 mm offset
of the printed board reference plane
6.3 Reference plane for printed boards with 2,54 mm offset
position
7 Dimensions used in the figures
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.