I.S. EN 60317-2:2012
Withdrawn
SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 2: SOLDERABLE POLYURETHANE ENAMELLED ROUND COPPER WIRE, CLASS 130, WITH A BONDING LAYER (IEC 60317-2:2012 (EQV))
Hardcopy , PDF
English
10-15-2012
06-09-2016
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, general notes and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion (nominal conductor diameters
from 0,250 mm up to and including 2,000 mm)
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerant
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oi
21 Loss of mass
23 Pin hole test
30 Packaging
Bibliography
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
Describes the requirements of solderable enamelled round copper winding wire of class 130 with a dual coating.
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Withdrawn
|
| Standards | Relationship |
| BS EN 60317-2:2012 | Identical |
| EN 60317-2:2012 | Identical |
| NBN EN 60317-2 : 2012 | Identical |
| DIN EN 60317-2:2013-06 | Identical |
| NF EN 60317-2 : 2013 | Identical |
| UNE-EN 60317-2:2013 | Identical |
| EN 60317-0-1:2014 | Specifications for particular types of winding wires - Part 0-1: General requirements - Enamelled round copper wire |
| IEC 60317-0-1:2013 | Specifications for particular types of winding wires - Part 0-1: General requirements - Enamelled round copper wire |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.