I.S. EN 61095:2009

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Characteristics of contactors
6 Product information
7 Normal service, mounting and transport conditions
8 Constructional and performance requirements
9 Tests
Annex A (normative) - Terminal marking and distinctive
        number
Annex B (normative) - Test sequences and number of
        samples
Annex C (normative) - Description of a method for
        adjusting the load circuit
Annex D (normative) - Determination of short-circuit
        power-factor
Annex E (normative) - Measurement of creepage
        distances and clearances
Annex F (normative) - Correlation between the nominal
        voltage of the supply system and the rated impulse
        withstand voltage of a contactor
Annex G (normative) - Hot wire ignition test
Annex H (normative) - Degrees of protection of enclosed
        contactor
Annex I (normative) - Requirements and tests for equipment
        with protective separation
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

Pertains to electromechanical air break contactors for household and similar purposes provided with main contacts intended to be connected to circuits the rated voltage of which does not exceed 440 V a.c. (between phases) with rated operational currents less than or equal to 63 A for utilization category AC-7a and 32 A for utilization categories AC-7b and AC-7c, and rated conditional short-circuit current less than or equal to 6 kA.