I.S. EN 61121:2013

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Requirements
5 Test conditions, materials, equipment and
   instrumentation
6 Preparation for testing
7 Performance measurements - General
   requirements
8 Tests for performance
9 Assessment of performance
10 Data to be reported
Annex A (normative) - Reference list
Annex B (normative) - Nominal and standard exhaust
        duct for tumble dryer testing
Annex C (informative) - Flow diagrams
Annex D (normative) - Test report - data to be reported
Annex E (normative) - Procedure to determine test
        load size where rated capacity is not declared
Annex F (normative) - Flexible initial moisture content
        method
Annex G (informative) - Assessment of evenness of
        drying
Annex H (informative) - Measurement of exhaust air
        volume
Bibliography
Annex ZA (normative) - Test procedure for a combined
         test sequence of cotton dry with full load and
         partial load
Annex ZB (normative) - Tolerances and control procedures
Annex ZC (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZZ (informative) - Coverage of Requirements of
         Commission Regulation (EU) No 932/2012 and
         Commission Delegated Regulation (EU)
         No 392/2012

Pertains to household electric tumble dryers of the automatic and non-automatic type, with or without a cold water supply and incorporating a heating device.