I.S. EN ISO 14373:2015

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Materials
6 Surface conditions
7 Edge conditions, form of component, and weld spacing
8 Electrodes
9 Weld assessment
10 Weld quality requirements
11 Multi-weld arrays
Annex A (informative) - Recommendations for spot welding
        equipment
Annex B (informative) - Typical spot welding conditions
Annex C (informative) - Partial list of steel types applicable to this
        International Standard
Bibliography

Defines requirements for resistance spot welding in the fabrication of assemblies of uncoated and metallic coated low carbon steel, comprising two or three sheets of metal, where the maximum single sheet thickness of components to be welded is within the range 0,4 mm to 3 mm, for the following materials: - uncoated steels; - hot-dip zinc or iron-zinc alloy (galvannealed) coated steel; - electrolytic zinc, zinc-iron, or zinc-nickel coated steel; - aluminium coated steel; - zinc-aluminium coated steel.