I.S. EN ISO 15012-2:2008
Withdrawn
View Superseded by
HEALTH AND SAFETY IN WELDING AND ALLIED PROCESSES - REQUIREMENTS, TESTING AND MARKING OF EQUIPMENT FOR AIR FILTRATION - PART 2: DETERMINATION OF THE MINIMUM AIR VOLUME FLOW RATE OF CAPTOR HOODS AND NOZZLES
Hardcopy , PDF
English
06-25-2008
09-30-2020
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Requirement
6 Equipment
7 Test method
8 Marking
9 Test report
Bibliography
Defines a method for establishing the minimum air volume flow rate required for captor hoods and nozzles to effectively capture fume and gases from welding and allied processes.
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Withdrawn
|
| SupersededBy |
| Standards | Relationship |
| EN ISO 15012-2:2008 | Identical |
| ISO 15012-2:2008 | Identical |
| BS EN ISO 15012-2:2008 | Equivalent |
| DIN EN ISO 15012-2:2008-06 | Equivalent |
| ISO 5167-3:2003 | Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full — Part 3: Nozzles and Venturi nozzles |
| EN 1093-1:2008 | Safety of machinery - Evaluation of the emission of airborne hazardous substances - Part 1: Selection of test methods |
| ISO 2602:1980 | Statistical interpretation of test results — Estimation of the mean — Confidence interval |
| ISO 5167-2:2003 | Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full — Part 2: Orifice plates |
| EN 626-2:1996+A1:2008 | Safety of machinery - Reduction of risk to health from hazardous substances emitted by machinery - Part 2: Methodology leading to verification procedures |
| ISO 5167-1:2003 | Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full — Part 1: General principles and requirements |
| ISO 12100-2:2003 | Safety of machinery — Basic concepts, general principles for design — Part 2: Technical principles |
| ISO 12100-1:2003 | Safety of machinery — Basic concepts, general principles for design — Part 1: Basic terminology, methodology |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.