I.S. EN ISO 1797-2:1995
Superseded
View Superseded by
DENTAL ROTARY EQUIPMENT - SHANKS - SHANKS MADE OF PLASTICS
01-12-2013
06-11-2017
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Committees responsible
National foreword
Foreword
Introduction
Specification
1. Scope
2. Normative references
3. Symbols and terms
4. Requirements
5. Test methods
6. Quality control
Annex
ZA. Normative references to international publications
with their relevant European publications
Figures
1. Type 1 shank
2. Type 2 and type 4 shank
3. Type 3 shank
4. Shank
5. Flattened portions, cross-section B-B of figure 4
Gives shanks of dental rotary instruments made of plastics materials and gives measurement methods for the verification of the dimensions.
| DevelopmentNote |
Supersedes I.S. EN 21797. (01/2012)
|
| DocumentType |
Standard
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| NEN EN ISO 1797-2 : 1995 | Identical |
| NF EN ISO 1797-2 : 1995 | Identical |
| NS EN ISO 1797-2 : 1ED 1995 | Identical |
| NBN EN ISO 1797-2 : 1995 | Identical |
| ISO 1797-2:1992 | Identical |
| DIN EN ISO 1797-2:1995-04 | Identical |
| BS EN ISO 1797-2:1995 | Identical |
| EN ISO 1797-2:1995 | Identical |
| UNE-EN ISO 1797-2:1995 | Identical |