I.S. EN ISO 18595:2007

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Material
   5.1 Form
   5.2 Types of aluminium alloys
6 Surface conditions
7 Edge distance, edge conditions, form of component
   and weld spacing
8 Electrodes
   8.1 Materials
   8.2 Dimensions
   8.3 Cooling electrodes
9 Weld assessment
   9.1 General
   9.2 Weldability test procedure
   9.3 Procedure qualification tests
   9.4 Production tests
   9.5 Frequency of testing
10 Weld quality requirements
   10.1 Weld diameter
   10.2 Weld dimensions
   10.3 Weld fracture mode
   10.4 Weld strength
   10.5 Weld appearance - Surface condition
11 Multi-weld arrays
Annex A (informative) Recommendations for spot welding
        equipment
Annex B (informative) Typical spot welding conditions
Annex C (informative) Non-exhaustive list of aluminium alloys
        covered by this International Standard
Annex D (informative) Typical information to appear on a welding
        procedure sheet for spot welding
Bibliography

Specifies requirements for resistance spot welding in the fabrication of assemblies of aluminium sheet, extrusions (both work- and age-hardening alloys) and/or cast material comprising two or three thicknesses of metal, where the maximum single (sheet) thickness of components to be welded is within the range 0,6 mm to 6 mm.