I.S. EN ISO 20028-1:2017
Withdrawn
View Superseded by
PLASTICS - THERMOPLASTIC POLYESTER (TP) MOULDING AND EXTRUSION MATERIALS - PART 1: DESIGNATION SYSTEM AND BASIS FOR SPECIFICATIONS (ISO 20028-1:2017)
Hardcopy , PDF
English
05-10-2017
04-30-2020
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
National Foreword
European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designation system
5 Examples of designations
Annex A (normative) - Designation of thermoplastic
polyesters
Bibliography
Provides a system of designation for thermoplastic polyester (TP) material, which can be used as the basis for specifications.
| DevelopmentNote |
Supersedes I.S. EN ISO 7792-1. (05/2017)
|
| DocumentType |
Standard
|
| Pages |
0
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Withdrawn
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 20028-1:2017 | Identical |
| EN ISO 20028-1:2017 | Identical |
| DIN EN ISO 20028-1:2017-07 | Equivalent |
| BS EN ISO 20028-1:2017 | Equivalent |
| UNE-EN ISO 20028-1:2017 | Equivalent |
| ISO 20028-2:2017 | Plastics — Thermoplastic polyester (TP) moulding and extrusion materials — Part 2: Preparation of test specimens and determination of properties |
| ISO 16396-1:2015 | Plastics — Polyamide (PA) moulding and extrusion materials — Part 1: Designation system, marking of products and basis for specifications |
| ISO 1628-5:1998 | Plastics — Determination of the viscosity of polymers in dilute solution using capillary viscometers — Part 5: Thermoplastic polyester (TP) homopolymers and copolymers |
| ASTM D 5927 : 2017 : REDLINE | Standard Classification System for and Basis for Specifications for Thermoplastic Polyester (TPES) Injection and Extrusion Materials Based on ISO Test Methods |
| ISO 1043-2:2011 | Plastics — Symbols and abbreviated terms — Part 2: Fillers and reinforcing materials |
| ISO 1043-1:2011 | Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.