I.S. EN ISO 5183-1:2000
Current
RESISTANCE WELDING EQUIPMENT - ELECTRODE ADAPTORS, MALE TAPER 1:10 - PART 1: CONICAL FIXING, TAPER 1:10
Hardcopy , PDF
English
01-01-2000
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Dimensions
4 Designation
5 Materials
6 Marking
Annex A (informative) Flat dimensions
Annex B (informative) Bibliography
Annex ZA (normative) Normative references to international
publications with their relevant European publications
Describes the dimensions and tolerances of resistance spot welding electrode adaptors where the fixing element for the cap (see ISO 5821) is a male taper of 1:10 and for which the electrode taper fits in conformance with ISO 1089.
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Supersedes |
| Standards | Relationship |
| NEN EN ISO 5183-1 : 2000 | Identical |
| EN ISO 5183-1:2000 | Identical |
| ISO 5183-1:1998 | Identical |
| NBN EN ISO 5183-1 : 2000 | Identical |
| NF EN ISO 5183-1 : 2000 | Identical |
| NS EN ISO 5183-1 : 1ED 2000 | Identical |
| BS EN ISO 5183-1:2001 | Identical |
| DIN EN ISO 5183-1:2000-07 | Identical |
| UNE-EN ISO 5183-1:2001 | Identical |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.