I.S. EN ISO 5458:1999
Withdrawn
View Superseded by
GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - GEOMETRICAL TOLERANCING - POSITIONAL TOLERANCING
Hardcopy , PDF
English
01-01-1999
01-09-2019
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative reference
3 Definitions
4 Establishment of positional tolerances
5 Tolerance combinations
Annex A (informative) Definitions
Annex B (informative) Former practice
Annex C (informative) Relation to the GPS matrix model
Annex D (informative) Bibliography
Explains positional tolerancing. This tolerancing method is applied to the location of a point, of a line nominally straight and of a surface nominally plane, e.g. the centre of a sphere, the axis of EL hole or shaft and the median surface of a slot.
| DocumentType |
Standard
|
| Pages |
20
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Withdrawn
|
| SupersededBy |
| Standards | Relationship |
| NEN EN ISO 5458 : 1999 | Identical |
| NBN EN ISO 5458 : 1999 | Identical |
| NF EN ISO 5458 : 1999 | Identical |
| EN ISO 5458:1998 | Identical |
| NS EN ISO 5458 : 1ED 1999 | Identical |
| DIN EN ISO 5458:2016-08 (Draft) | Identical |
| ISO 5458:1998 | Identical |
| BS EN ISO 5458:1999 | Identical |
| UNE-EN ISO 5458:1999 | Identical |
| DIN EN ISO 5458:1999-02 | Equivalent |
| ISO/TR 14638:1995 | Geometrical product specification (GPS) — Masterplan |
| ISO 5459:2011 | Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems |
| ISO 2692:2014 | Geometrical product specifications (GPS) — Geometrical tolerancing — Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR) |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| ISO 3098-1:2015 | Technical product documentation — Lettering — Part 1: General requirements |
| ISO 14660-1:1999 | Geometrical Product Specifications (GPS) — Geometrical features — Part 1: General terms and definitions |
| ISO 1660:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Profile tolerancing |