IEC 60071-1:2006+AMD1:2010 CSV

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Procedure for insulation co-ordination
6 Requirements for standard withstand voltage tests
Annex A (normative) - Clearances in air to assure a
        specified impulse withstand voltage installation
Annex B (informative) - Values of rated insulation
        levels for 1 kV < U[M] = 245 kV for highest
        voltages for equipment U[M] not standardized
        by IEC based on current practice in some
        countries
Bibliography

IEC 60071-1:2006+A1:2010 applies to three-phase a.c. systems having a highest voltage for equipment above 1 kV. It specifies the procedure for the selection of the rated withstand voltages for the phase-to-earth, phase-to-phase and longitudinal insulation of the equipment and the installations of these systems. It also gives the lists of the standard withstand voltages from which the rated withstand voltages should be selected. This standard recommends that the selected withstand voltages should be associated with the highest voltage for equipment. This association is for insulation co-ordination purposes only. The requirements for human safety are not covered by this standard. Although the principles of this standard also apply to transmission line insulation, the values of their withstand voltages may be different from the standard rated withstand voltages. The apparatus committees are responsible for specifying the rated withstand voltages and the test procedures suitable for the relevant equipment taking into consideration the recommendations of this standard. NOTE In IEC 60071-2, Application Guide, all rules for insulation co ordination given in this standard are justified in detail, in particular the association of the standard rated withstand voltages with the highest voltage for equipment. When more than one set of standard rated withstand voltages is associated with the same highest voltage for equipment, guidance is provided for the selection of the most suitable set. It has the status of a horizontal standard in accordance with IEC Guide 108. This consolidated version consists of the eigth edition (2006) and its amendment 1 (2010). Therefore, no need to order amendment in addition to this publication.