IEC 60317-0-3:2008+AMD1:2013 CSV

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, general notes,
   and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation (nominal conductor
   diameters up to and including 1,600 mm)
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) - Dimensions for intermediate
        nominal conductor diameters (R 40)
Annex B (informative) - Method for the calculation
        of linear resistance
Annex C (informative) - Resistance

IEC 60317-0-3:2008+A1:2013 gives the general requirements of enamelled round aluminium winding wires with or without a bonding layer. Technical changes from the previous edition include clarification to appearance requirements, revisions to the wire size ranges applicable to the flexibility and adherence tests, and clarification that pin hole test requirements are under consideration. This consolidated version consists of the third edition (2008) and its amendment 1 (2013). Therefore, no need to order amendment in addition to this publication.



This publication is to be read in conjunction with the IEC 60851 series.