IEC 60745-2-5:2010

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General conditions for the tests
7 Classification
8 Marking and instructions
9 Protection against access to live parts
10 Starting
11 Input and current
12 Heating
13 Leakage current
14 Moisture resistance
15 Electric strength
16 Overload protection of transformers and associated
   circuits
17 Endurance
18 Abnormal operation
19 Mechanical hazards
20 Mechanical strength
21 Construction
22 Internal wiring
23 Components
24 Supply connection and external flexible cords
25 Terminals for external conductors
26 Provision for earthing
27 Screws and connections
28 Creepage distances, clearances and distances through
   insulation
29 Resistance to heat, fire and tracking
30 Resistance to rusting
31 Radiation, toxicity and similar hazards
Annexes
Annex K (normative) - Battery tools and battery packs
Annex L (normative) - Battery tools and battery packs
                      provided with mains connection
                      or non-isolated sources
Annex M (normative) - Safety of working stands for operation
                      with hand-held motor-operated electric
                      tools
Annex AA (normative) - Additional requirements for saws with
                       a riving knife
Annex BB (normative) - Additional requirements for lower guards
                       for saws without a riving knife
Bibliography

IEC 60745-2-5:2010 deals with the safety of hand-held motor-operated or magnetically driven electric tools, specific requirements for all types of circular saws. The rated voltage being not more than 250 V for single-phase a.c. or d.c., and 440 V for three-phase a.c. tools. This standard does not apply to saws used with abrasive wheels. The principal changes in this edition as compared with the fourth edition are as follows:
- clause 17 introduction of endurance tests in practical use for the guards of all types of saws;
- clause 19 clarifications and editorial improvements in respect to the guarding;
- annex M editorial improvements.

This publication is to be read in conjunction with IEC 60745-1:2006.