IEC 60851-5:2008+AMD1:2011 CSV

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Test 5: Electrical resistance
4 Test 13: Breakdown voltage
5 Test 14: Continuity of insulation (applicable to
  enamelled round and tape wrapped round wire)
6 Test 19: Dielectric dissipation factor (applicable to
  enamelled wire and bunched wire)
7 Test 23: Pin hole test
Annex A (informative) - Dissipation factor methods

IEC 60851-5:2008+A1:2011 specifies the following tests:
- Test 5: Electrical resistance;
- Test 13: Breakdown voltage;
- Test 14: Continuity of insulation;
- Test 19: Dielectric dissipation factor.
Significant revisions to the previous edition include the following points:
- In Subclause 5.3, the addition of the use of carbon brush electrodes for the counting discontinuities during the high voltage continuity test, as an alternative to the V-groove pulley electrode; and
- Clarifications in the breakdown voltage test for round wires larger than 2,500 mm and for fibrous covered wires. This consolidated version consists of the fourth edition (2008) and its amendment 1 (2011). Therefore, no need to order amendment in addition to this publication.