IEC 61045-1:1991

Foreword
Preface
SECTION ONE - SCOPE
Clause
1 Scope
SECTION TWO - GENERAL
2 General
   2.1 Related documents
   2.2 Units, symbols and terminology
   2.3 Preferred values
   2.4 Marking
SECTION THREE - QUALITY ASSESSMENT PROCEDURES
3 Quality assessment procedures
   3.1 Qualification Approval/Quality Assessment Systems
   3.2 Primary Stage of Manufacture
   3.3 Manufacturing stages in a Factory of an approved
        manufacturer in a non-IECQ Member Country and
        Sub-contracting
   3.4 Manufacturer Approval
   3.5 Approval procedures
   3.6 Qualification Approval Procedures
   3.7 Capability Approval Procedures
   3.8 Quality Conformance Inspection
   3.9 Alternative test methods
   3.10 Unchecked parameters
SECTION FOUR - TEST AND MEASUREMENT PROCEDURES
4 Test and measurement procedures
   4.1 General
   4.2 Standard atmospheric conditions
   4.3 Drying
   4.4 Visual examination and check of dimensions
   4.5 Resistance
   4.6 Resistance ratio
   4.7 Functional characteristics
   4.8 Insulation resistance (insulated styles only)
   4.9 Voltage proof (insulated networks only)
   4.10 Variation of resistance with temperature
   4.11 Non-linear properties
   4.12 Overload
   4.13 Robustness of terminations
   4.14 Solderability
   4.15 Resistance to soldering heat
   4.16 Rapid change of temperature
   4.17 Shock
   4.18 Vibration
   4.19 Climatic sequence
   4.20 Damp heat, steady state
   4.21 Endurance
   4.22 Component solvent resistance
   4.23 Solvent resistance of the marking
Appendix A: Interpretation of sampling plans and
            procedures as described in IEC Publication
            410 for use within the IEC Quality Assessment
            System for Electronic Components
Appendix B: Rules for the preparation of detail
            specification for capacitors and resistors for
            electronic equipment

Establishes standard terms, inspection procedures and methods oftest for qualification and capability approval.