IEC 62642-2-2:2010
Current
Alarm systems - Intrusion and hold-up systems - Part 2-2: Intrusion detectors - Passive infrared detectors
Hardcopy , PDF
English, English - French
10-07-2010
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Functional requirements
5 Marking, identification and documentation
6 Testing
Annex A (normative) - Dimensions and requirements of
the standardised test magnets
Annex B (normative) - General testing matrix
Annex C (informative) - Walk test diagrams
Annex D (normative) - Procedure for calculation of
average temperature difference
Annex E (informative) - Basic detection target for the
basic test of detection capability
Annex F (informative) - Equipment for walk test velocity
control
Annex G (informative) - Immunity to visible and near
infrared radiation - Notes on calibration of
the light source
Annex H (informative) - Example list of small tools
Annex I (informative) - Test for resistance to re-orientation
of adjustable mountings
Bibliography
IEC 62642-2-2:2010 is for passive infrared detectors installed in buildings and provides for security grades 1 to 4 (see IEC 62642-1), specific or non-specific wired or wire-free detectors, and uses environmental classes I to IV (see IEC 62599-1). A detector shall fulfil all the requirements of the specified grade.
| Committee |
TC 79
|
| DevelopmentNote |
Supersedes IEC 60839-2-2 and IEC 60839-2-6. (10/2011) Stability Date: 2017. (12/2017)
|
| DocumentType |
Standard
|
| Pages |
94
|
| PublisherName |
International Electrotechnical Committee
|
| Status |
Current
|
| Supersedes |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.