IEEE 287 : 2007

1 Overview
  1.1 Scope
  1.2 Purpose
2 General requirements and definitions
  2.1 Mechanical
  2.2 Electrical
  2.3 Environmental
3 Recommended electrical test procedures for GPC and LPC
  3.1 Statement
  3.2 Reflection coefficient
  3.3 Connector repeatability
  3.4 Insertion loss and phase measurement
  3.5 Shielding effectiveness
  3.6 Direct-current contact resistance
4 Recommended mechanical test procedures for GPC and LPC
  4.1 Mechanical requirements specified
  4.2 Recommended mechanical test procedures
5 Connector summary table
  5.1 Introduction
  5.2 How to use this summary table
  5.3 Definitions
Annex A (informative) Inner conductor gap study
Annex B (informative) Inner conductor slotted contact study
Annex C (informative) Detail specifications for precision
        coaxial 14 mm conectors
Annex D (informative) Detail specifications for precision
        coaxial 7 mm connectors
Annex E (informative) Detail specifications for precision
        coaxial Type N conectors
Annex F (informative) Detail specifications for precision
        coaxial 3.5 mm conectors
Annex G (informative) Detail specifications for precision
        coaxial 2.92 mm conectors
Annex H (informative) Detail specifications for precision
        coaxial 2.4 mm conectors
Annex I (informative) Detail specifications for precision
        coaxial 1.85 mm conectors
Annex J (informative) Detail specifications for precision
        coaxial 1 mm conectors
Annex K (informative) Bibliography

Describes coaxial connectors for precision electrical measurements to 110 GHz. The frequency range of the standard is increased from 65 GHz to 110 GHz since in the market exists a 1 mm connector with a rated upper minimum operating frequency of 110 GHz. The members of the subcommittee felt, in view of this, the scope of the project should be changed to incorporate this advantage.