JIS B 1022:1999
Superseded
View Superseded by
Tolerances for fasteners -- Part 3: Plain washers for bolts, screws and nuts -- Product grades A and C
English
04-30-1999
12-23-2016
This Japanese Industrial Standard specifies a selection of tolerances for use in the preparation of the product standards for plain washers, grades A and C, for bolts, screws and nuts with nominal thread diameters from 1 mm up to and including 150 mm. Deviations from the tolerances specified in this Standard are permitted in product standards only for valid technical reasons. It is recommended that these tolerances also be used for non-standard plain washers. In cases where the maximum material principle according to JIS B 0023 is appropriate to certain features of certain products in the product standards, other tolerances may be applicable.
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
Japanese Standards Association
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| ISO 4759-3:1991 | Identical |
| JIS B 0023:1996 | Technical drawings -- Geometrical tolerancing -- Maximum material requirement and least material requirement |
| JIS B 1021:2003 | Tolerances for fasteners -- Part 1: Bolts, screws, studs and nuts -- Product grades A, B and C Part 1: Bolts, screws, studs and nuts - Product grades A, B and C |
| JIS B 1084:2007 | Fasteners -- Torque/clamp force testing |
| JIS B 1091:2003 | Fasteners -- Acceptance inspection |
| JIS B 1256:1998 | Plain washers |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.