NBN EN 1612-2 : 2000 + A1 2008
Withdrawn
RUBBER AND PLASTICS MACHINES - REACTION MOULDING MACHINES - PART 2: SAFETY REQUIREMENTS FOR REACTION MOULDING PLANT
01-12-2013
05-01-2010
Foreword
0 Introduction
1 Scope
2 Normative references
3 Definitions
4 List of hazards
5 Safety requirements and/or measures
6 Verification of the safety requirements and/or
measures
7 Information for use
Annex ZA (informative) Clauses of this European Standard
Addressing Essential Requirements
or Other Provisions of EU Directives
Specifies the essential health and safety requirements for the design of reaction moulding plant with the exception of metering and mixing units. It does not completely specify the hazards arising from the use of highly flammable additives, e.g. pentane used as a blowing agent, because these hazards depend to a large extent on the additives and process used.
| DevelopmentNote |
2000 Edition Re-Issued in November 2008 & incorporates AMD 1 2008. (01/2009)
|
| DocumentType |
Standard
|
| PublisherName |
Belgian Standards
|
| Status |
Withdrawn
|
| Standards | Relationship |
| DIN EN 1612-2:2000-09 | Identical |
| UNE-EN 1612-2:2001 | Identical |
| I.S. EN 1612-2:2000 | Identical |
| BS EN 1612-2 : 2000 | Identical |
| EN 1612-2:2000+A1:2008 | Identical |