NFPA 22 : 2018
Superseded
View Superseded by
WATER TANKS FOR PRIVATE FIRE PROTECTION
01-01-2018
05-23-2022
Chapter 1 - Introduction
Chapter 2 - Referenced Publications
Chapter 3 - Definitions
Chapter 4 - General Information
Chapter 5 - Welded-Carbon Steel and Composite
Concrete and Carbon Steel Gravity Tanks
and Suction Tanks
Chapter 6 - Factory-Coated, Bolted Carbon Steel Tanks
Chapter 7 - Pressure Tanks
Chapter 8 - Wood Gravity Tanks and Suction Tanks
Chapter 9 - Embankment-Supported Coated Fabric
Suction Tanks
Chapter 10 - Concrete Gravity Tanks and Suction Tanks
Chapter 11 - Fiberglass-Reinforced Plastic Tanks
Chapter 12 - Tank and Tower Foundations in the Ground
Chapter 13 - Steel Tank Towers
Chapter 14 - Pipe Connections and Fittings
Chapter 15 - Valve Enclosures and Frost Protection
Chapter 16 - Tank Heating
Chapter 17 - Acceptance Test Requirements
Chapter 18 - Inspection, Testing, and Maintenance of
Water Tanks
Annex A - Explanatory Material
Annex B - Typical Installations
Annex C - Informational References
Index
This standard provides the minimum requirements for the design, construction, installation, and maintenance of tanks and accessory equipment that supply water for private fire protection, including the following: (1) Gravity tanks, suction tanks, pressure tanks, and embankment-supported coated fabric suction tanks (2) Towers (3) Foundations (4) Pipe connections and fittings (5) Valve enclosures (6) Tank filling (7) Protection against freezing
| DocumentType |
Standard
|
| PublisherName |
National Fire Protection Association
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |