PREN 2002-01 : 200P3

0 Introduction
1 Scope
2 References
3 Definitions
4 Health and safety
5 Principle
6 Testing requirements
7 Test report
Annex A (normative) Types of test piece to be used for sheet
                    and strip with thickness less than 8 mm
Annex B (normative) Types of non-machined test piece to be
                    used in the case of bar, section and wire
                    with a diameter or thickness less than or
                    equal to 8 mm
Annex C (normative) Types of machined test piece to be used
                    in the case of bar, section, plate and
                    wire with diameter or thickness greater
                    than 8 mm and for forgings and castings
Annex D (normative) Types of test piece to be used in the case
                    of tubes

Specifies the requirements for the tensile testing of metallic materials at ambient temperature for aerospace applications.