SAE AMS6488H
Withdrawn
Steel, Bars and Forgings 5.0Cr - 1.3Mo - 0.5V - (0.38 - 0.43C)
Hardcopy , PDF
English
01-16-2008
01-16-2008
1 SCOPE
2 APPLICABLE DOCUMENTS
3 TECHNICAL REQUIREMENTS
4 QUALITY ASSURANCE PROVISIONS
5 PREPARATION FOR DELIVERY
6 ACKNOWLEDGEMENT
7 REJECTIONS
8 NOTES
Covers a low-alloy steel in the form of bars, forgings, and forging stock.
| DocumentType |
Standard
|
| Pages |
9
|
| PublisherName |
SAE International
|
| Status |
Withdrawn
|
| Supersedes |
This specification covers a low-alloy steel in the form of bars, forgings, and forging stock.These products have been used typically for parts requiring a steel capable of through-hardening to a minimum hardness of 50 HRC in section thicknesses up to 12 inches (305 mm) with relatively high levels of strength, fatigue resistance, ductility, and thermal stability in service from -100 degrees to +1000 degrees F (-73 degrees to +538 degrees C), but usage is not limited to such applications.Certain design and processing procedures may cause these products to become susceptible to stress-corrosion cracking after heat treatment; SAE ARP 1110 recommends practices to minimize such conditions.
| SAE AMS7464D | Bolts and Screws, Steel, Low-Alloy Heat Resistant 222,000 psi (1517 MPa) Tensile Strength Hardened and Tempered, Roll Threaded |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.