SAE J2436_201607
Superseded
View Superseded by
Accessory Drive Tensioner Test Standards
Hardcopy , PDF
English
07-01-2016
11-20-2023
1. SCOPE
2. REFERENCES
3. GENERAL
4. CONTAMINATION TEST
5. HOT BOX DURABILITY TEST
6. LIFT FEATURE TEST
7. OZONE TEST
8. SAFETY DROP TEST
9. SNAP TEST
10. CORROSION TEST
11. NOTES
To document test procedures and set-ups that address known failure modes for Accessory Drive automatic tensioners This SAE Standard does not encompass the pulley or pulley bearing.
| DocumentType |
Standard
|
| Pages |
11
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
To document test procedures and set-ups that address known failure modes for Accessory Drive automatic tensioners This SAE Standard does not encompass the pulley or pulley bearing. The sample sizes and acceptance criteria should be determined by agreement between the original equipment manufacturer (OEM) and the supplier.The failure modes to be addressed are:Test Factors include:NOTE: The Belt Drive Committee recommends that this spec be run using test parts that are close to the upper and lower specifications for load output and damping (tails testing).
| SAE J2198_201304 | Glossary - Automatic Belt Tensioner |
| ASTM D 1149 : 2016-02 | TEST METHODS FOR RUBBER DETERIORATION - CRACKING IN AN OZONE CONTROLLED ENVIRONMENT |
| SAE J2198_201304 | Glossary - Automatic Belt Tensioner |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.