SAE J373_201205
Current
Housing Internal Dimensions for Single- and Two-Plate Spring-Loaded Clutches
Hardcopy , PDF
English
05-31-2012
This SAE Recommended Practice defines the minimum internal dimensions for clutch housings to provide adequate clearance for single- and two-plate spring-loaded clutches.
| DocumentType |
Standard
|
| Pages |
3
|
| ProductNote |
This standard is now stabilized
|
| PublisherName |
SAE International
|
| Status |
Current
|
| Supersedes |
This SAE Recommended Practice defines the minimum internal dimensions for clutch housings to provide adequate clearance for single- and two-plate spring-loaded clutches. (See Figure 1.)Consult SAE J617 for housing flange dimensions. Consult SAE J618 and J619 for spring-loaded clutch flywheel dimensions F and G and other dimensional data.Table 1 provides housing minimum internal dimensions for single- and two-plate spring-loaded clutches.
| SAE J2407_201711 | Clutch Installation and Release Linkage Requirements for Truck and Bus Application |
| SAE J2408_201801 | Clutch Requirements for High-Torque Truck and Bus Engines |
| SAE J1806_201708 | Clutch Dimensions for Truck and Bus Applications |
| SAE J2555_201709 | Vehicle Idle Gear Rattle Evaluation Procedure |
| SAE J2469_201709 | Clutch Application Powertrain Startability Rating Requirements for Truck and Bus Applications |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.