UNE-EN 1218-1:2000

Foreword
      Introduction
1 Scope
2 Normative references
3 Definitions
4 List of hazards
5 Safety requirements and/or measures
      5.1 Controls
      5.2 Protection against mechanical hazards
      5.3 Protection against non-mechanical hazards
6 Information for use
      6.1 Warning devices
      6.2 Marking
      6.3 Instruction handbook
Annex A (informative) Safe working practice
Annex B (normative) Geometrical performance for the
                    tool holder (spindle) (taken from
                    ISO 7988:1988)
Annex C (informative) Examples of safety related control
                      systems
Annex D (informative) Bibliography
Annex ZA (informative) Clauses of this European Standard
                       addressing essential requirements
                       or other provisions of EU
                       Directives

Defined requirements and/or measures to remove the hazards and limit the risk on single end tenoning machines with sliding table, referred to as "machine". These are designed to cut solid wood, fibreboard, chipboard, plywood and materials where they are covered with plastic edgings or laminates.