BS 3894-1:1965
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Method for converting elongation values for steel Carbon and low alloy steels
Hardcopy , PDF
09-15-1999
English
06-03-1965
Cooperating organizations
Foreword
Method
Section one. General
1. Scope
2. Symbols
3. Definitions
4. Basic formula
Section two. Application of the factors and tables
5. Conversion from one proportional gauge length to
another proportional gauge length
6. Conversion from one non-proportional gauge length to
another non-proportional gauge length for test
pieces of equal cross-sectional area
7. Conversion from a proportional gauge length to a
non-proportional gauge length
8. Conversion from a non-proportional gauge length to
another non-proportional gauge length for test
pieces of different cross-sectional areas
9. Use of charts 1 and 2
Section three. Tables
1. Conversion factors: proportional gauge lengths
2. Conversion factors: non-proportional gauge lengths
3. Conversion factors from 5.65 square root So to
non-proportional gauge lengths
4. Elongation values on 5.65 square root So
corresponding to those obtained on 4 square root So
gauge length
5. Elongation values on 5.65 square root So
corresponding to those obtained on 2 inch gauge
length
6. Elongation values on 5.65 square root So
corresponding to those obtained on 4 inch gauge
length
7. Elongation values on 5.65 square root So
corresponding to those obtained on 8 inch gauge
length
8. Elongation values on 4 square root So corresponding
to those obtained on 2 inch gauge length
9. Elongation values on 4 square root So corresponding
to those obtained on 4 inch gauge length
10. Elongation values on 4 square root So corresponding
to those obtained on 8 inch gauge length
Chart 1. Elongation conversion chart: 5.65 square root
So to 2 inch and 8 inch gauge lengths
Chart 2. Elongation conversion chart: 4 square root So
to 2 inch and 8 inch gauge lengths
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.