Specifies the requirements for the production and supply of hot-rolled structural steel bars and sections.
This Standard specifies the requirements for the production and supply of hot-rolled structural steel bars and sections.This Standard is intended for general structural and engineering applications. All grades specified in this Standard are suitable for—(a) welding in accordance with AS/NZS 1554, Parts 1, 2, 5 and 7; and(b) fastening, as specified in AS 3990, AS 4100, AS/NZS 4600, AS 5100.6 and NZS 3404.This Standard does not cover the following:(i) Structural steel—welded I sections.(ii) Carbon steels and carbon-manganese steels—Hot-rolled bars and semi-finished products.(iii) Steel reinforcing bars for concrete.Requirements for product conformity to this Standard are given in Appendix B.NOTES: 1 Guidelines for purchasers on requirements that should be specified by the purchaser and those that should or may be agreed on at the time of enquiry and order are given in Appendix A.2 Guidelines on cold-bending of rounds, flats and squares during fabrication are given in Appendix C.
Originated in Australia as part of AS A1—1925.Originated in New Zealand as AS/NZS 3679.1:1996.Previous edition 2010.Fourth edition 2016. Originated in Australia as part of AS A1-1925. Originated in New Zealand as AS/NZS3679.1:1996. Previous edition 2010. Fourth edition 2016.
|Metallic materials - Tensile testing at ambient temperature
|Structural steel welding Welding of sheet steel structures
|Non-destructive testing - Penetrant testing of products and components
|Guide to the protection of structural steel against atmospheric corrosion by the use of protective coatings Hot dip galvanizing
|Mechanical equipment - Steelwork (Reconfirmed 2016)
|Method for impact tests on metals Charpy V-notch (Reconfirmed 2017)
|AS/NZS ISO 9001:2016
|Quality management systems - Requirements
|Structural steel welding Welding of steel structures subject to high levels of fatigue loading
|Methods for the analysis of iron and steel Sampling iron and steel for chemical analysis
|Sampling procedures for inspection by attributes Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection (Reconfirmed 2016)
|Cold-formed steel structures
|Steel structures (Reconfirmed 2016)
|Sampling procedures for inspection by attributes Introduction to the ISO 2859 attribute sampling system (Reconfirmed 2016)
|Sampling procedures and charts for inspection by variables for percent nonconforming
|Bridge design - Steel and composite construction
|Non-destructive testing - Magnetic particle testing of ferromagnetic products, components and structures (Reconfirmed 2022)
|Structural steel welding Welding of steel structures
|Numerical values - Rounding and interpretation of limiting values (Reconfirmed 2018)
|Structural steel welding Stud welding (steel studs to steel)
|Water storage tanks for fire protection systems
|Road safety barrier systems and devices Road safety devices
|Qualification of welders for fusion welding of steels - Additional requirements for Australia and New Zealand
|Scaffolding Couplers and accessories
|Bridge design Timber
|Hot-dip galvanized steel bolts and associated nuts and washers for tower construction
|Road tank vehicles for dangerous goods Road tank vehicles for flammable liquids
|Bridge design Rehabilitation and strengthening of existing bridges
|Scaffold decking components
|Pressure equipment - Boilers
|Above‑ground burial structures
|Composite structures - Composite steel-concrete construction in buildings
|Road tank vehicles for dangerous goods Tankers for toxic and corrosive cargoes
|Structural steelwork - Fabrication and erection
|Bridge design Steel and composite construction
|Steel for the reinforcement of concrete
Access your standards online with a subscription
Simple online access to standards, technical information and regulations.
Critical updates of standards and customisable alerts and notifications.
Multi-user online standards collection: secure, flexible and cost effective.