Customer Support: 131 242

  • Shopping Cart
    There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

BS 4571:1994

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

On-load tap-changers

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

15-03-1994

Superseded date

15-03-1998

Superseded by

BS EN 60214:1998

$531.66
Including GST where applicable

Section one. General
1. Scope
2. Service conditions
3. Information required with enquiries and orders
Section two. Definitions
4. Definitions relating to on-load tap-changers
     (excluding motor-drive mechanisms)
5. Definitions relating to motor-drive mechanisms
Section three. Requirements for on-load tap-changers
6. Rating
7. Design and construction
8. Type tests
9. Routine tests
10. Nameplate
Section four. Requirements for motor-drive mechanisms
for on-load tap-changers
11. Design and construction
12. Type tests
13. Routine tsts
13. Routine tests
14. Nameplate
Appendix A - Supplementary information on switching
              duty relating to tap-changers with
              resistor transition only
Appendix B - Method of determining the equivalent
              temperature of the transition resistor
              using power pulse currents
Appendix C - Simulated circuits for service duty and
              breaking capacity tests

Applies to oil and gas filled tap changers except for tap changers used for railway rolling stock applications.

Committee
PEL/14
DevelopmentNote
Supersedes BS 4571: 1978. IMPLEMENTATION OF CENELEC HD 367. DRAFT FOR COMMENT 91/24675 DC
DocumentType
Standard
Pages
48
PublisherName
British Standards Institution
Status
Superseded
SupersededBy

IEC 60270:2000+AMD1:2015 CSV High-voltage test techniques - Partial discharge measurements
IEC 60354:1991 Loading guide for oil-immersed power transformers
IEC 60296:2012 RLV Fluids for electrotechnical applications - Unused mineral insulating oils for transformers and switchgear
IEC 60076-3:2013 Power transformers - Part 3: Insulation levels, dielectric tests and external clearances in air
IEC 60137:2017 Insulated bushings for alternating voltages above 1000 V
IEC 60076-1:2011 Power transformers - Part 1: General
IEC 60144:1963 Degrees of protection of enclosures for low-voltage switchgear and controlgear

$531.66
Including GST where applicable