DIN EN 1636-5:1999-12
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS PIPING SYSTEMS FOR NON-PRESSURE DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON UNSATURATED POLYESTER RESIN (UP) - PART 5: FITNESS FOR PURPOSE OF THE JOINTS
Hardcopy , PDF
English
12-01-2013
01-07-2006
Foreword
Introduction
1. Scope
2. Normative references
3. Definitions
4. Interchangeability
5. Joints
5.1 Dimensions
5.2 Flexible and reduced-articulation joints with
elastomeric sealing components
This standard is included in DIN Handbook 171. Describes the characteristics of the fitness for purpose of glass-reinforced thermosetting plastics based on unsaturated polyester resin (GRP-UP) piping systems intended to be used for non-pressure drainage and sewerage. Also specifies the relevant test parameters for the test methods referred to in this standard which are applicable to the joints to be used in GRP-UP piping systems to be used for the conveyance of surface water or sewage below ground, outside buildings, at temperature up to 50 degree C.
| DevelopmentNote |
Supersedes DIN 19565-1. (07/2006)
|
| DocumentType |
Standard
|
| Pages |
16
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| EN 1636-5 : 1997 | Identical |
| NF EN 1636-5 : 1997 | Identical |
| NBN EN 1636-5 : 1997 | Identical |
| I.S. EN 1636-5:1998 | Identical |
| NS EN 1636-5 : 1ED 1997 | Identical |
| NEN EN 1636-5 : 1997 | Identical |
| BS EN 1636-5:2001 | Identical |
| UNE-EN 1636-5:1998 | Identical |