EN 61557-1:2007

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
  4.1 Operating uncertainty (B), percentage operating
       uncertainty (B [%])
  4.2 Rated operating conditions
  4.3 Battery check facility
  4.4 Terminals
  4.5 Class of protection
  4.6 Class of pollution
  4.7 Overvoltage category
  4.8 Measuring category
  4.9 Electromagnetic compatibility
  4.10 Vibration test
5 Marking and operating instructions
  5.1 Marking
  5.2 Operating instructions
6 Tests
  6.1 Influence of position
  6.2 Influence of temperature
  6.3 Influence of the supply voltage
  6.4 Battery check facility
  6.5 Protection class
  6.6 Terminals
  6.7 Mechanical requirements
  6.8 Marking and operating instructions
Bibliography
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

This part of IEC 61557 specifies the general requirements for measuring and monitoring equipment for testing the electrical safety in low voltage distribution systems with nominal voltages up to 1 000 V a.c. and 1 500 V d.c. When measuring equipment or measuring installations involve measurement tasks of various measuring equipment covered by this series of standards, then the part of this series of standards relevant to each of the measurement tasks is applicable. This second edition replaces and cancels the first edition published in 1997. It constitutes a technical revision. The following changes were made with respect to the previous edition: a) revision of the definitions; b) addition of influence quantities E9 and E10; c) the subclause on Electromagnetic compatibility was complemented; d) inclusion of performance monitoring devices in the introduction; e) addition of new requirements for operating instructions.