EN ISO 11296-1:2018

European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Pipes at the 'M' stage.
6 Fittings at the 'M' stage
7 Ancillary components
8 Fitness for purpose of the installed lining system
  at the 'I' stage
9 Installation practice
Bibliography

ISO 11296-1:2018 specifies the requirements and test methods for plastics piping systems intended to be used for the renovation of underground non-pressure drainage and sewerage networks, which are operated as gravity systems and subjected to a maximum surcharge pressure of 0,5 bar[1]. It is applicable to pipes and fittings, as manufactured, as well as to the installed lining system. It is not applicable to the existing pipeline or any non-structural sprayed coatings or annular filler.ISO 11296-1:2018 gives the general requirements common to all relevant renovation techniques.[1] 1 bar = 0,1 MPa = 0,1 N/mm2 = 105 N/m2.