I.S. EN ISO 11296-1:2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
PLASTICS PIPING SYSTEMS FOR RENOVATION OF UNDERGROUND NON-PRESSURE DRAINAGE AND SEWERAGE NETWORKS - PART 1: GENERAL (ISO 11296-1:2018)
Hardcopy , PDF
English
01-01-2011
15-04-2018
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
National Foreword
European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Pipes at the 'M' stage.
6 Fittings at the 'M' stage
7 Ancillary components
8 Fitness for purpose of the installed lining system
at the 'I' stage
9 Installation practice
Bibliography
Defines the requirements and test methods for plastics piping systems intended to be used for the renovation of underground non-pressure drainage and sewerage networks, which are operated as gravity systems and subjected to a maximum surcharge pressure of 0,5 bar.
| DevelopmentNote |
Supersedes I.S. EN 13566-1. (05/2011)
|
| DocumentType |
Standard
|
| Pages |
29
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| Supersedes |
| Standards | Relationship |
| ISO 11296-1:2009 | Identical |
| EN ISO 11296-1:2011 | Equivalent |
| EN ISO 11296-1:2018 | Identical |
| UNE-EN ISO 11296-1:2011 | Equivalent |
| ISO 11296-1:2018 | Identical |
| DIN EN ISO 11296-1:2011-07 | Equivalent |
| BS EN ISO 11296-1:2011 | Equivalent |
| ISO 4427-1:2007 | Plastics piping systems — Polyethylene (PE) pipes and fittings for water supply — Part 1: General |
| ISO 11295:2017 | Classification and information on design and applications of plastics piping systems used for renovation and replacement |
| ISO 11296-3:2009 | Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks — Part 3: Lining with close-fit pipes |
| ISO 4633:2015 | Rubber seals — Joint rings for water supply, drainage and sewerage pipelines — Specification for materials |