AS 5200.000-2005

1 - AS 5200.000-2005 TECHNICAL SPECIFICATION FOR PLUMBING AND DRAINAGE PRODUCTS - PROCEDURES FOR CERTIFICATION OF PLUMBING...
4 - PREFACE
5 - CONTENTS
6 - INTRODUCTION
7 - 1 SCOPE AND GENERAL
7 - 1.1 Scope
7 - 1.2 Reference documents
7 - 2 DEFINITIONS
7 - 2.1 Approved user
7 - 2.2 Conformity Assessment Body (CAB)
7 - 2.3 Licence (WaterMark)
7 - 2.4 Manufacture's (or supplier's) warranty
8 - 2.5 Permitted product
8 - 2.6 Plumbing Code of Australia (PCA)
8 - 2.7 Recognized testing laboratory
8 - 2.8 Specification
8 - 3 MARKING
8 - 4 CERTIFICATION
8 - 4.1 Procedure for WaterMark certification
8 - 4.2 Minimum levels of certification
8 - 4.3 Unlisted Products
9 - 4.4 Initial requests
9 - 4.5 Renewal
9 - 4.6 Notification
9 - 4.7 Procedures
9 - 4.8 Product with integral components
9 - 4.9 Products outside the WaterMark Scheme
12 - 5 SCHEDULE OF SPECIFICATIONS
19 - APPENDIX A - REFERENCED STANDARDS SPECIFICATIONS
23 - APPENDIX B - A GUIDE TO THE USE OF WATERMARK ON PLUMBING AND DRAINAGE PRODUCTS SUPPLIED UNDER THE WMCS
23 - B1 THE REQUIREMENT FOR CERTIFICATION MARKING
23 - B2 PLANNING FOR PRODUCT MARKING
23 - B3 MARKING WHERE SPACE IS LIMITED
23 - B4 POSITIONING OF CERTIFICATION MARKS
24 - B5 OBTAINING APPROVAL FROM THE CAB
26 - APPENDIX C - A GUIDE TO THE PROCESS OF CERTIFICATION OF THOSE PRODUCTS THAT ARE NOT LISTED BUT REQUIRE CERTIFICATION
26 - C1 INTRODUCTION
26 - C2 THE PROCESS
26 - C3 PRODUCT/INSTALLATION REVIEW
27 - C4 DEVELOPMENT OF A TECHNICAL SPECIFICATION
27 - C5 APPLICATION TO TECHNICAL REVIEW COMMITTEE
28 - C6 TECHNICAL GROUP REVIEW PROCESS
28 - C7 PUBLICATION OF THE SPECIFICATION
29 - C8 FINALISATION
30 - APPENDIX D - PRODUCTS OUTSIDE THE WATERMARK SCHEME

Specifies Standards, Australian Technical Specifications (ATS) and other Specifications for certification of plumbing and drainage products that are generally intended for installation, replacement, repair, alteration and maintenance by authorized persons in works described by Clause A0.2 Scope of the Plumbing Code of Australia (PCA).

This Standard nominates Standards and Australian Technical Specifications (ATS) for certification of plumbing and drainage products that are generally intended for installation, replacement, repair, alteration and maintenance by authorized persons in works described by ClauseA0.2 Scope of the Plumbing Code of Australia (PCA).The PCA refers to materials and products throughout the PCA. For the purposes of this Standard the term products is assumed to include materials.

Originated as MP 52-1988.
Previous edition 2005.
Revised and redesignated as AS 5200.000-2005.