AS 5200.000-2006

1 - AS 5200.000-2006 PLUMBING AND DRAINAGE PRODUCTS - PROCEDURES FOR CERTIFICATION OF PLUMBING AND DRAINAGE PRODUCTS
4 - PREFACE
5 - CONTENTS
6 - INTRODUCTION
7 - 1 SCOPE AND GENERAL
7 - 1.1 Scope
7 - 1.2 Reference documents
7 - 2 DEFINITIONS
7 - 2.1 Approved user
7 - 2.2 Conformity Assessment Body (CAB)
7 - 2.3 Licence (WaterMark)
7 - 2.4 Manufacturer's (or supplier's) warranty
7 - 2.5 Permitted product
8 - 2.6 Plumbing Code of Australia (PCA)
8 - 2.7 Recognized testing laboratory
8 - 2.8 Specification
8 - 3 MARKING
8 - 4 CERTIFICATION
8 - 4.1 Procedure for WaterMark certification
8 - 4.2 Minimum levels of certification
9 - 4.3 Unlisted products
9 - 4.4 Initial requests
9 - 4.5 Renewal
9 - 4.6 Notification
9 - 4.7 Procedures
9 - 4.8 Product with integral components
9 - 4.9 Products outside the WaterMark Scheme
12 - 5 SCHEDULE OF SPECIFICATIONS
18 - 6 PRODUCTS USED IN URBAN WATER INDUSTRY NETWORK INFRASTRUCTURE
19 - APPENDIX A - REFERENCED STANDARDS SPECIFICATIONS
24 - APPENDIX B - A GUIDE TO THE USE OF WATERMARK ON PLUMBING AND DRAINAGE PRODUCTS SUPPLIED UNDER THE WMCS
24 - B1 REQUIREMENT FOR CERTIFICATION MARKING
24 - B2 PLANNING FOR PRODUCT MARKING
24 - B3 MARKING WHERE SPACE IS LIMITED
24 - B4 POSITIONING OF CERTIFICATION MARKS
25 - B5 OBTAINING APPROVAL FROM THE CAB
27 - APPENDIX C - A GUIDE TO THE PROCESS OF CERTIFICATION OF THOSE PRODUCTS THAT ARE NOT LISTED BUT REQUIRE CERTIFICATION
27 - C1 INTRODUCTION
27 - C2 THE PROCESS
27 - C3 PRODUCT/INSTALLATION REVIEW
27 - C4 DEVELOPMENT OF A TECHNICAL SPECIFICATION
28 - C5 APPLICATION TO TECHNICAL REVIEW COMMITTEE
29 - C6 TECHNICAL GROUP REVIEW PROCESS
29 - C7 PUBLICATION OF THE SPECIFICATION
29 - C8 FINALIZATION
30 - APPENDIX D - PRODUCTS OUTSIDE THE WATERMARK SCHEME

This Standard nominates Standards and Australian Technical Specifications (ATS) for certification of plumbing and drainage products that are generally intended for installation, replacement, repair, alteration and maintenance by authorized persons in works described the Scope of the Plumbing Code of Australia (PCA).

This Standard nominates Standards and Australian Technical Specifications (ATS) for certification of plumbing and drainage products that are generally intended for installation, replacement, repair, alteration and maintenance by authorized persons in works described the Scope of the Plumbing Code of Australia (PCA).NOTE: The PCA refers to materials and products throughout the document. For the purposes of this Standard, the term products includes materials.

Originated as MP 52-1988.
Previous edition 2005.
Revised and redesignated as AS 5200.000-2005.
Second edition 2006.