AS 60060.3-2008

1 - AS 60060.3-2008 High-voltage test techniques - Part 3: Definitions and requirements for on-site testing
4 - PREFACE
5 - CONTENTS
7 - INTRODUCTION
9 - 1 Scope
9 - 2 Normative references
10 - 3 Terms and definitions
14 - 4 Common tests and checks on a measuring system
14 - 4.1 Acceptance test
14 - 4.2 Performance test
15 - 4.3 Performance check
15 - 4.4 Record of performance
15 - 5 Tests with direct voltage
15 - 5.1 General
15 - 5.2 Definitions for direct voltage tests
16 - 5.3 Test voltage
16 - 5.4 Measurement of the test voltage
17 - 5.5 Tests and checks on measuring systems
17 - 5.6 Withstand voltage test procedure
17 - 6 Tests with alternating voltage
17 - 6.1 General
18 - 6.2 Definitions for alternating voltage tests
18 - 6.3 Test voltage
19 - 6.4 Measurement of the test voltage
20 - 6.5 Tests and checks on measuring systems
20 - 6.6 Withstand voltage test procedure
20 - 7 Tests with lightning impulse voltage
20 - 7.1 General
20 - 7.2 Definitions for lightning impulse voltage tests
23 - 7.3 Test voltage
23 - 7.4 Measurement of the test voltage and determination of the impulse voltage shape
24 - 7.5 Tests and checks on measuring systems
24 - 7.6 Withstand voltage test procedures
25 - 8 Tests with switching impulse voltage
25 - 8.1 General
25 - 8.2 Definitions for switching impulse voltage tests
28 - 8.3 Test voltage
28 - 8.4 Measurement of the test voltage and determination of the impulse shape
29 - 8.5 Tests and checks on measuring systems
29 - 8.6 Withstand voltage test procedures
30 - 9 Tests with very low frequency voltages
30 - 9.1 General
30 - 9.2 Definitions for very low frequency voltage tests
30 - 9.3 Test voltage
31 - 9.4 Measurement of the test voltage
32 - 9.5 Tests and checks on measuring systems
32 - 9.6 Test procedure
32 - 10 Tests with damped alternating voltages
32 - 10.1 General
32 - 10.2 Definitions for damped alternating voltage tests
33 - 10.3 Test voltage
34 - 10.4 Measurement of the test voltage
34 - 10.5 Tests and checks on measuring systems
35 - 10.6 Test procedure

Proposes requirements for on-site high-voltage tests with direct voltage, alternating voltage, lightning impulse voltage and switching impulse voltage on equipment with highest voltage greater than 1 kV.

First published as AS 60060.3-2008.