ASTM E 949 : 1988 : R2004
Withdrawn
Standard Test Method for Total Moisture in a Refuse-Derived Fuel Laboratory Sample (Withdrawn 2004)
English
03-25-1988
07-31-2011
CONTAINED IN VOL. 11.04, 2009 Describes the measurement of the total moisture in RDF as it exists at the time it is sampled.
| Committee |
D 34
|
| DocumentType |
Test Method
|
| Pages |
4
|
| ProductNote |
Reconfirmed 2004
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Withdrawn
|
| Supersedes |
1.1 This test method covers the measurement of the total moisture in RDF as it exists at the time it is sampled. Because of its empirical nature, strict adherence to test procedures are required for valid results. The standard is available to producers, vendors, and consumers as a total, two-stage moisture method.
1.2 Since RDF can vary from extremely wet (water saturated) to relatively dry, special emphasis must be placed on sampling, sample preparation, and the method of determination.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 790 : 2015 : REDLINE | Standard Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Samples |
| ASTM E 829 : 2016 | Standard Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.