ASTM F 2882M : 2012
Withdrawn
View Superseded by
Standard Specification for Screws, Alloy Steel, Heat Treated, 1170 MPa Minimum Tensile Strength [Metric] (Withdrawn 2017)
English
10-01-2012
07-19-2017
CONTAINED IN VOL. 01.08, 2017 Specifies the requirements for quenched and tempered alloy steel screws 0.060 through 1[1/2] inches in diameter having a minimum ultimate tensile strength of 170 KSI.
| Committee |
F 16
|
| DocumentType |
Standard
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Withdrawn
|
| SupersededBy | |
| Supersedes |
1.1This specification covers the requirements for quenched and tempered alloy steel screws 1.6 mm through 48 mm in diameter having a minimum ultimate tensile strength of 1170 MPa.
1.2The following hazard caveat pertains only to the test method portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM F 2328M : 2017 : REDLINE | Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts (Metric) |
| ASME B18.24 : 2015 | PART IDENTIFYING NUMBER (PIN) CODE SYSTEM STANDARD FOR B18 FASTENER PRODUCTS |
| ASME B18.2.7.1M : 2002(R2007) | METRIC 12-SPLINE FLANGE SCREWS |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.