ATS 5200.052-2005

1 - ATS 5200.052-2005 TECHNICAL SPECIFICATION FOR PLUMBING AND DRAINAGE PRODUCTS - METALLIC-BODIED INLET PRESSURE CONTROL...
4 - PREFACE
5 - CONTENTS
6 - 1 SCOPE
6 - 2 APPLICATION
6 - 3 REFERENCED DOCUMENTS
7 - 4 DEFINITIONS
7 - 5 MATERIALS
7 - 5.1 General
7 - 5.2 Metallic materials
7 - 5.2.2 Copper
7 - 5.2.3 Copper alloy
7 - 5.2.4 Dezincification-resistant (DR) copper alloy
7 - 5.2.5 Stainless steel
7 - 6 MARKING
8 - 7 VOID
8 - 8 DESIGN
8 - 8.1 End connectors
8 - 8.2 Wrenching flats
8 - 9 PERFORMANCE REQUIREMENTS AND TEST METHODS
8 - 9.1 Products in contact with drinking water
8 - 9.2 Torque test
8 - 9.3 Leakage test
8 - 9.4 Flow rate test
8 - 9.5 Outlet pressure test
8 - 9.6 Endurance test
8 - 10 TEST SEQUENCE AND TEST SAMPLE PLAN
9 - 11 PRODUCT DOCUMENTATION
9 - 11.1 Product data
9 - 11.2 INSTALLATION INSTRUCTIONS
10 - APPENDIX A - MEANS FOR DEMONSTRATING COMPLIANCE WITH THIS AUSTRALIAN TECHNICAL SPECIFICATION
10 - A1 SCOPE
10 - A2 RELEVANCE
10 - A3 PRODUCT CERTIFICATION
10 - A4 DEFINITIONS
10 - A4.1 Batch release test
10 - A4.2 Production batch
10 - A4.3 Sample
10 - A4.4 Sampling plan
10 - A4.5 Type test batch
11 - A4.6 Type testing (TT)
11 - A5 TESTING
11 - A5.1 Type testing
11 - A5.2 Batch release testing
11 - A5.3 Retesting

This Technical Specification sets out requirements for the design, construction, testing and performance of metallic-bodied inlet pressure control valves.

This Technical Specification sets out requirements for the design, construction, testing and performance of metallic-bodied inlet pressure control valves. The valves are primarily intended for use in cold water supply systems at continuous working pressures not exceeding 1400kPa.

First published as ATS 5200.052-2005